ActiveImage Protector installation may stop at 99%

Summary

The ActiveImage Protector installation might stop at 99%.

Requirements:
– Use the old kernel of CentOS/RedHat Enterprise 5.x Linux.
(the kernel older than 2.6.18-371.9.1.el5.)
– Use after ActiveImage Protector 4.1 Linux Edition.
– The Snapshot Working Area (aiptmpfile.img) is large.
*The Snapshot Working Area reserves 3% of the total size of the backup source.

The installation stops in the following message:

————————————————————–
Relabeling selinux labels
————————————————————–

Cause

Creating the temporary area on the old kernel can lead to significantly slower processing.

e.g.
Kernel of issue : 2.6.18-371.9.1.el5

– Create the temporary Area of 1.7GB.
-> It will finish in a few minutes.

– Create the temporary Area of 10GB.
-> It takes four hours or longer.

The kernel that functions properly.
2.6.18-371.11.1.el5 (CentOS/RedHat Enterprise 5.10) or later

Resolution 1

In the event of a kernel update:

1) Uninstall ActiveImage Protector

  # <Media Path>/NetJapanInstaller-4.5.x

    Press the  Uninstall

2) Update the kernel

# yum install kernel

3) Install ActiveImage Protector

  # <Medeia Path>/NetJapanInstaller-4.5.x

    Press the Install

Resolution 2

In the event of the sectmap file replacement:

1) Run the command

# <Medeia Path>/scripts/installer

It will halt at the next step.
---
Excluding /var/opt/aipsnap/aiptmpfile.img ...
---

2) Press the Ctrl+C
3) Replace the attached sectmap40 file with the original sectmap file.

  # cp -f /<sectmap40 Path> /etc/sectmap

  # chmod 755 /etc/sectmap

4) Creation of temporary Area

#/opt/Actiphy/mkaiptmp setup

* All press the Enter.

5) Start aipservice

# serviceNetJapanAIP start

6) Start AIP console

# /opt/NetJapan/AIProtector

Attachments

sectmap40 (21,742 bytes)

Target Product

- ActiveImage Protector 4.1 / 4.5 Linux

(13451077607321)

Search

Actiphy Help Center