Setting Default Performance

Summary

Adjust default task performance settings in the console menu under [Preference] > [General] > [Default Performance]. Move the slider slightly left to configure the settings for the maximum CPU load for task execution. 

・Version 7.0.0.8643 or later
Enter a specific value for the default performance setting.
You are recommended to set the value around 95 to 100 (default value).

・Version 6.5.2.7778 or earlier

Move the slide bar to adjust the default performance.
Moving the slide bar to the extreme left, the process time substantially increases.
Please move the slider slightly to the left, when necessary.

To confirm the setting value, refer to the configuration file at the following location.

Location of the configuration file:

Earlier Version 

Windows Edition
C:\Program Files (x86)\Actiphy\ActiveImage Protector\aip.ini
Linux Edition
/opt/Actiphy/aip.ini

AIP2022

Windows Edition
C:\Program Files\Actiphy\ActiveImage Protector\aip.ini

Linux Edition
/opt/Actiphy/aip.ini

Open the "aip.ini" file with a text editor and review the specified parameter in the [aipcopy] section.

[aipcopy] default_task_perf_slide=100

Choose a workload value between 100 and 95, where "0" is "light workload" and "100" is "fast."
Avoid selecting "94" or lower, as it will significantly reduce performance. The updated setting takes effect from the next task execution. 

Target Product

ActiveImage Protector 2016 / 2018 /2022

(13451174254873)