Functional enhancements in version 7.7.0.9999

Details

Some features were enhanced in version 7.7.0.9999, but the processing method differs by recovery target. When KVM or Proxmox is selected as the recovery target, Windows iSCSI is used. For all other recovery targets, VHD Mount is used.

This applies to:

• HyperBack (backup source: KVM or Proxmox)

• HyperRecovery (recovery target: KVM or Proxmox)

• vStandby (virtual standby target: KVM only)

• HyperStandby (target host: KVM only)

• Virtualization (Type: for Linux KVM or Proxmox)

Note for iSCSI processing:
During HyperBack or HyperRecovery, the final step (unmounting iSCSI) may take longer. Progress may pause around 97.X% for 5–6 minutes while Windows confirms the iSCSI target is busy which is required process for safe unmount. This is expected behavior—please wait until the process reaches 100%.

HyperRecovery Task Log（UTC+09:00）

01/15/2026 08:39:47.467 UnMount iSCSI target (10.123.1.67, iqn.2003-01.org:103.20260115-173654)
01/15/2026 08:45:47.876 [0] Disconnect iSCSI target return 0, 0

ISCSI Initiator log (logs\ISCSIInitiator\AipCopyWLH64_XXXXXXXX.log）

2026-01-15 17:45:47.875 LOG_ERROR [iSCSI initiator] iSCSIDisconnectToTargetEx Failed, error code:4026466368, error msg: The device in the session is currently in use, and you cannot log out the session.(IScsiMgr.cpp):484 
2026-01-15 17:45:47.876 LOG_INFO  [iSCSI initiator] iSCSIDisconnectToTargetEx end. result status:4026466368 (IScsiMgr.cpp):505 

Re: Error code: 4026466368 detected with Microsoft Error Lookup Tool

# for decimal -268500928 / hex 0xefff0040
  ISDSC_DEVICE_BUSY_ON_SESSION                                   iscsierr.h
# The session cannot be logged out since a device on that session is currently being used.

1) The following events are logged in the Windows System Event Log and do not indicate a problem: 

MSiSCSI ID 116　information (multiple)
Kernel-PnP ID 225 warning (multiple)
iScsiPrt ID 20 Error
iScsiPrt ID 10 Error
iScsiPrt ID 1 Error
disk ID 157 Warning

2) The iSCSI Initiator status may not update immediately. After HyperBack or HyperRecovery completes, the iSCSI Initiator Properties window may still show an inactive status. If this occurs, click Refresh. After a short time, the IQN entries will be cleared.

This is expected behavior and does not indicate a problem.

Please highlight the items that are reconnecting and click [Disconnect]. After a while, they will be deleted from the list. Since they are actually unmounted, the symptoms observed are the same as those of the inactive ones. This issue is currently under investigation.

Target Product

- ActiveImage Protector 2022

(54500430344089)